|
|
|
|
 Great stuff and congrats on your first print. I have had the same problem as yourself with the Pumkin print I did, print starting in different places a few times and slid sideways like yours in the print process. I actually think its the downloaded code doing this and not the program were using as when you load it into the program it may get corrupted and you get the bad result but load it again and its ok. Bit of a lottery at times but all part of the fun.  Current builds:-C57,Zero, Lamborghini Countach, Caldercraft HMS Agamemnon,Robi,R2-D2, MFH Cobra .
|
|
|
 Rank: Pro Groups: Joined: 24/08/2009 Posts: 48,827 Points: -13,348
|
Congrat's on your first print, Mr Owl looks great
|
|
|
 Rank: Semi-Pro Level 1    Groups: Registered
Joined: 17/11/2015 Posts: 60 Points: 183 Location: USA
|
Thanks everyone!
Carl, I fiddled around with the repetier host centering as you mentioned, and I believe that will help a lot.
I seem to be getting leakage around the nozzle assembly. I tried tightening the nozzle again, but it still has melted PLA leaking out. Anyone have this issue? Thanks
|
|
|
 Rank: Super-Elite    Groups: Registered
Joined: 17/12/2013 Posts: 3,982 Points: 11,974 Location: NY, USA
|
Not had that issue.I think if I remember you had to tighten it when it was hot but I am not sure.Check the instructions.That may be your problem. Carl ps Here is a link to the official build diary where Mr T talks about tightening the nozzle when it is hot http://forum.us.model-sp...spx?g=posts&t=17252
|
|
|
Rank: Super-Elite Groups: Registered
Joined: 17/12/2013 Posts: 3,982 Points: 11,974 Location: NY, USA
|
AgentRev,
did you fix your nozzle leaking. If not you can use heat proof threadlock to seal the thread an prevent leakage
Carl
|
|
|
Rank: Semi-Pro Level 1 Groups: Registered
Joined: 17/11/2015 Posts: 60 Points: 183 Location: USA
|
Oh thanks, I will probably try that, as I already tried tightening it while hot.
|
|
|
Rank: Semi-Pro Level 1 Groups: Registered
Joined: 17/11/2015 Posts: 60 Points: 183 Location: USA
|
Isn't the printer supposed to move to the center of the bed to begin printing?
Mine is not doing that. Does anyone know how I can adjust that?
Thanks
Edit: actually it looks as though it may be okay now. It just isn't in the exact center, so I'm not sure what the issue could be.
Fidget spinners seem to be the sudden rage here in the USA, so wish me luck. lol
|
|
|
|
Guest
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
UK
