Welcome Guest Search | Active Topics | Log In | Register

2 Pages <12
Piston "jamming" in cylinder liner Options
#21 Posted : 28 August 2015 22:58:58

Rank: Pro

Build-Diary Medal: Build-Diary Medal of Honour
Groups: Registered

Joined: 23/07/2013
Posts: 120
Points: 336
Location: Brisbane Australia
Been there done that.
Check this post on piston jamming BDC.
#22 Posted : 22 July 2016 09:30:05

Rank: Newbie

Groups: Registered

Joined: 22/07/2016
Posts: 1
Points: 3
I have also experienced the same problem at TDC I don't have just a tight piston it is jammed tight even after connecting the pull start. I even tried the one good pull on the starter and the engine seized. I had to disassemble the engine to free it up. and it still required a bit of effort to remove the piston from the sleeve.
Thank you Dave
#23 Posted : 22 July 2016 12:12:26

Rank: Vice-Master
Active Service Medal: 500 post active service MedalBuild-Diary Medal: Build-Diary Medal of HonourRed Medal: Red Medal
Groups: Registered

Joined: 05/04/2013
Posts: 540
Points: 1,630
Location: England
Hi Dave welcome to the forum!

Where about's are you with your build?

Has it been run yet or are you getting these issues as soon as you have put it together?
Finished 3D Printer, RB7, Hummer, Skyrider drone & Combat tank collection

Users browsing this topic
Guest (2)
2 Pages <12
Forum Jump  
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.

Powered by YAF | YAF © 2003-2009, Yet Another Forum.NET
This page was generated in 0.088 seconds.