|
|
|
|
Issue 24
Picture 1 shows the contents of this issue.
Assembling the Freezer Display
Check which way around the freezer base and freezer display goes, picture 2. Glue the ice creams into the base as shown in picture 3. Test fit this part first.
Take off the protective film from both sides of the display window, picture 4. Again, test fit this part first making sure you have the correct orientation before glueing into place, picture 5. Glue the display top on the display window, picture 6.
Take the display base to the ice cream parlour, and check you have the right orientation, picture 7.
Glue the back wall in place making sure the smooth side is facing towards you. Use a drop of instant glue to secure it in the base, picture 8. Now attach the floor, glueing it to the back wall and base, picture 9.
Add the ice cream freezer, using a drop of glue to hold it in place, picture 10.
Finally, add Sally as shown in picture 11.
That complete the assembly from this issue.Markwarren attached the following image(s):
|
|
|
|
|
Issue 25
Assembling the Ice Cream Parlour Display
Retrieve the ice cream parlour scene from the last issue and place the two side walls in the same way as you have done before, picture 1.
Take the three flag sheets and peel off two of each colour. Carefully, bend the flags in half, sticking the two points together, but leaving a gap at the top to feed through the wire as shown in picture 2.
Place one of the pink flags onto the wire making sure that the side is about halfway along the wire as illustrated in picture 3. With that flag fixed in place, position all the other flags as shown in picture 4.
Before we fix the flags in place, glue the two ice cream cones to the top of the freezer inserting the pins into the holes.
Take the flag assembly and fit the wire into the holes on the side walls, picture 5 and then bend the wire either end as shown in picture 6. Finally, glue Snoopy in place next to Sally.
Picture 7 shows the completed assembly for this issue.Markwarren attached the following image(s):
|
|
|
|
|
Issue 26 Part 1
Picture 1 shows the parts for this issue
Assembling the Base and Background Parts
Take the grass base and apply PVA glue to the top, picture 2. Place the glue painted grass base in a pot of some kind and sprinkle some of the green flocking over the glued area. Pat the flocking down to give a good adhesion, picture 3. Allow this to dry for 24 hours, picture 4.
Take the back wall, making sure you have it the right way around, and glue in place the two cloud pieces, picture 5. Now take the base, noting its orientation, and the back wall and glue them in place as shown in picture 6 and 7.
That completes part 1 of this assembly.
Markwarren attached the following image(s):
|
|
|
|
|
Issue 26 part 2
Retrieve the four packs of pillow parts, picture 8. Break apart the wadding and stuff it all into the pillow, picture 9. Glue the end using PVA glue and hold it together using a clamp, picture 10. Do the same with the remaining three pillow and set aside to enable the glue to set.
Once the glue is dry, trim off any frayed ends and then place them in the bed scene as illustrated in pictures 11 and 12.
Finally glue the bed onto the base and then glue the flowerpot stand.
Picture 13 shows the completed assembly for this issue.
Markwarren attached the following image(s):
|
|
|
|
Guest
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
UK
